在排除漏電隱患的情況下，建議 選擇柔軟的刷子或軟布 配合專用清洗液 進(jìn)行面板清潔。清潔時(shí)， 不要踩踏面板 ，也不要在面板很熱的時(shí)候直接將冷的清洗液噴在上面，清洗的力度也不要太大， 避免對(duì)表面造成破壞 

In the process of photovoltaic power generation, the inverter, as one of the core devices, has many internal electronic components. When it continues to work, the heat will be collected inside the cavity, leading to higher and higher temperature.  

Therefore, the installation position of the inverter should do a good job of shading and ventilation, to ensure air circulation and convection.   Because the wind in autumn is generally more than in summer, so in autumn, it is also conducive to the cooling of the inverter.  

03  

The Angle of PV module also has an effect on the power generation  

The picture  

The picture  

The picture  

The "dip Angle" refers to the Angle between the surface of the PV module and the surface water plane. The dip Angle and orientation of the module are also factors that determine the power generation.   Generally speaking, module tiling is conducive to summer photovoltaic power generation, module tilt is conducive to winter photovoltaic power generation.  

In order to adapt to the light conditions throughout the year, the Angle will not be too small or too large, when the photovoltaic module installation will try to find the "best Angle".   In this Angle, will be conducive to the four seasons of power generation.  

Thus it can be seen  

Hot summer weather is not conducive to photovoltaic power generation  

The temperature is best in autumn  

Hence the most efficient generation  

Especially in the cool autumn  

When the clouds are thin  

Will make the photovoltaic power generation up!  The up!   up!  

The picture  

Precautions for cleaning photovoltaic equipment  

The picture  

Because the photovoltaic panel is exposed in the air for a long time, the panel will inevitably accumulate dust over time, affecting the power generation effect.   So, what should we pay attention to when cleaning photovoltaic power generation equipment?   Let's study together!  

01  

Ensure personal safety and device safety  

The picture  

Because most of the household photovoltaic is installed on the inclined roof, when cleaning, it is necessary to avoid falling injury or sliding abrasion. If you have difficulties cleaning yourself, you can find professionals to clean.  

In addition, because the photovoltaic equipment needs many brackets and screws to support and fix, attention should also be paid to not damage the support structure and cause safety risks when cleaning the components.  

02  

The best working hours to avoid photovoltaics  

The picture  

Attention must be paid to the selection of dust removal time. In the daytime, the sunlight is sufficient, the photovoltaic power generation equipment is in operation, and there will be high voltage in the equipment. The dust removal work should be avoided during this period.   Therefore, it is recommended that you choose the morning before sunrise or evening after the sun goes down to clean the work, if possible, it is best to power off the photovoltaic system to ensure safety.  

03  

Choose the right cleaning method  

The picture  

It is recommended to choose a soft brush or soft cloth together with special cleaning liquid to clean the panel in the case of eliminating the leakage danger.   When cleaning, do not step on the panel, and do not spray cold cleaning liquid directly on the panel when it is very hot. The intensity of cleaning is not too large to avoid damage to the surface.